Golden 24 hours principle ----all the responses should be done within 24 hours!Step.1 订单 Order Step.2 开模分析 DFMEA Step.3 模具设计要求 Tooling BOM Form Step.4 模具 2D 图纸 Tooling 2D DrawingStep.5 开工通知单 Cutting Tooling Notice Step.6 生产进度表 Weekly Report Step.7 模具3D Tooling 3D drawing Step.8...

Step.1 订单 Order1. 确认订单 Confirm Order2. 出示发票 Issuer PI3. 产品图纸&要求 下达工程 Provide Engineers with part drawings and special requirements

Step.2 开模分析 DFMEADFMEA(Design Failure Mode & Effect Analysis ) should be prepared before the 2D tooling design ,which should include P/L, Gate location, Ejector pins and the basic structure of tooling as well as the comments for any parts design defects. This is a good way to save much time and cost for tooling design and fabrication. ...

DFMEA REPORT SHOW ...

DFMEA REPORT SHOW ...

BOM Form

Tooling 2D drawing

Cutting Tooling Noticd

Weekly Report

3D drawing

Dimension Report of T1

Packing Information

CDContents: 1. Tooling 2D 2. Tooling 3D 3. 检查报告 Dimension Report 4. 照片 Photograph 5. 录像 Video

3000 cycles testing for tooling ejecting system

Plastic Mould Operation Manual