The important consideration should be end product and what your definition of "REGRIND" is. Reprocessing your own internal scrap (if kept clean and uncontaminated with anything else) is a significantly different question basis than using unknown or unclassified "regrind" from outside sources.As to the end ...

It's a small plastic injected piece that will be submitted to short period of time (2 seconds) of high temperature (95-105ºC approx.) in every cycle; this high temperature is produced by a filament where electric current passes through (like a house light bulb but hotter) for no mo...

Gate types The two main gate systems are manually trimmed gates and automatically trimmed gates. The following examples show where they are used:1. Sprue gate: Used for large components, the gate mark is visible in component and no runner is required. e.g.: bucket molding (backside ...

Ejection system types l Pin ejection—Cylindrical pins eject the finished component. In the case of square and rectangular components, a minimum of four pins (at the four corners) are required. In the case of cylindrical components, three equidistant pins (i.e. 120° apart) are requir...

Hard Tooling -Steel/aluminum tools are used for the injection molding process for prototype or bridge, but these tools are mostly used for high volume production (100’s-100,000’s).-Steel/aluminum tools typically range in price from thousands to tens of thousands of dollars. And pend...

Hard Tooling -Steel/aluminum tools are used for the injection molding process for prototype or bridge, but these tools are mostly used for high volume production (100’s-100,000’s).-Steel/aluminum tools typically range in price from thousands to tens of thousands of dollars. And pend...

Longxiang as a experienced player in the line, we strive for customer satisfactions. So we ensure you that we will follow up every product we sell.Longxiang provide necessary technology and technical supports for all our products. We have decades of technicians available to assist in the as...

Plastic MaterialFeaturesApplicable products POMLow friction coefficient,Good geometric stabilityEspecially suitable for the production of gear and bearing PA PA6Good elasticity,High impact strength,Water absorption is biggerSuitable for making general machinery parts, reduce friction wear parts, trans...

...

Plastic Mould Operation Manual

In general, For plastic injection mold: 50% deposit, 30% before T1 sample, 20% after you confirm the sampleFor plastic injection parts: 50% deposit, 50% before shipmentFor rapid prototype: 100% deposit

In general1-2 days for DFMEA report2-3 days for mold design and making mold drawing25-40 days for mold making.